Guide

Home backup during outages

A portable power station can cover a short list of plug-in devices. It is not a substitute for a permanently installed standby generator or a home battery sized for an entire service panel. This page is a planning method. It is not electrical advice and it is not a claim that any model will keep your house running.

Start with one circuit’s worth of plugs

List devices you would actually move onto the station:

  • A refrigerator’s running watts are often far below the watts it draws for a second when the compressor starts. The label or manual may show running watts and a locked-rotor or surge figure. If it does not, this site cannot tell you whether a station will start that fridge.
  • A Wi-Fi router is often near 10 W and runs continuously, so a small station can cover it for many hours if nothing else is on.
  • A few LED bulbs or a lamp are a small, steady load. Add them in the calculator instead of guessing “the lights.”
  • Microwaves, kettles, space heaters, and hair dryers are short, heavy loads. A 1,500 W heater can exceed the continuous output of many mid-size stations even when the watt-hour capacity looks large.

Runtime for a cycling fridge depends on the duty cycle you enter. A 40% duty cycle is a placeholder so the field is not stuck at 100%. Measure your own fridge if the outage plan depends on it. The estimate also ignores inverter idle draw, so a very light load can be shorter in practice than the math suggests.

Stations at or above 1,000 Wh and 1,500 W

The filter below is only a way to scan this dataset. It is not a recommendation, and it does not mean each model can run a refrigerator.

Outlets, transfer, and what not to improvise

Plugging a station into a wall outlet with a homemade backfeed cord can energize house wiring and is a known hazard to line workers. Connecting a station to a panel, inlet, or transfer switch is work for a licensed electrician using listed equipment. This site does not provide wiring steps.

Some spec sheets list a UPS switchover time in milliseconds. That figure describes how the manufacturer characterizes the transfer. It is not a promise that every computer, network device, or other sensitive load will ride through an outage. Test the combination you care about before you rely on it.

Do not use these pages to decide whether a power station can run medical or life-support equipment. Follow the device manufacturer and a clinician’s instructions.