Anker

Anker SOLIX F3000

Anker SOLIX F3000: 3,072 Wh, LiFePO4, 3,600 W continuous AC.

  • Capacity 3,072 Wh
  • Continuous AC 3,600 W
  • Weight 91.5 lb
  • Chemistry LiFePO4
  • Solar input 2,400 W

Where to buy

Buying verdict

Who it's for

Buyers sizing backup power for a specific set of devices. Use the 3,072 Wh nominal battery capacity to estimate runtime for your loads.

Estimate runtime for your devices

Who should skip it

Anyone whose combined running AC loads exceed 3,600 W, the published continuous rating.

The comparisons below use the closest catalog model within 20% of this station's rated battery capacity. Compare with Pecron E3600LFP.

Pros

  • Supports up to 2,400 W of manufacturer-rated solar input with a compatible setup.

Cons

  • Heavier than the Pecron E3600LFP (91.5 lb vs. 79 lb).

Manufacturer specs

Each figure links to the page it was read from. Use the ? buttons for plain-English definitions.

Listings change. Confirm the current spec sheet before you buy. Nothing here is a safety certification or a promise that a particular appliance will run.

Manufacturer specifications for Anker SOLIX F3000
Spec Published figure Source
Capacity How much energy it stores — a 1,000 Wh unit runs a 100 W device about 8–9 hours after typical losses. 3,072 Wh ankersolix.com Checked
Continuous AC output The most wattage it can power at once without an overload warning. 3,600 W ankersolix.com Checked
Battery chemistry LiFePO4 ankersolix.com Checked
Weight How heavy the station is to lift and carry. 91.5 lb (41.5 kg) ankersolix.com Checked
Solar input The most solar charging wattage the station is rated to accept. 2,400 W max ankersolix.com Checked
Expansion Up to 24 kWh with compatible expansion batteries ankersolix.com Checked

Derived buyer metrics & UPS notes

  • Wh/lb Calculated from capacity (Wh) ÷ weight (lb). Higher means more stored energy per pound carried; hidden if either input is missing. 33.6 Wh/lb calculated from published capacity ÷ weight

Solar charging

All solar panels

Panel compatibility is unverified for this model. Check the station's voltage, current, and connector limits with the manufacturer before connecting a panel.

Runtime examples

Calculator defaults: 90% depth of discharge, 85% inverter efficiency, 95% DC efficiency. Planning estimates, not lab measurements.

Use your own loads
Estimated runtime for Anker SOLIX F3000 under common loads
Load scenario Estimated runtime
Compact fridge (70 W running, 40% duty) 83 h 56 min
Laptop 65 W USB-C + Wi-Fi router 10 W AC 34 h 29 min
12 V compressor cooler (45 W, 40% duty) 145 h 55 min

Will Anker SOLIX F3000 run specific appliances?

Notes from the source pages

  • 240 V AC output requires two F3000 units and the Double Power Hub.

Frequently asked questions

What is the battery capacity of the Anker SOLIX F3000?

The manufacturer lists 3,072 Wh of nominal battery capacity. Usable energy depends on the load and power conversion losses.

How much continuous AC power does the Anker SOLIX F3000 supply?

The manufacturer lists 3,600 W of continuous AC output.

What is the Anker SOLIX F3000's surge rating?

A verified surge rating is unavailable in the catalog.

What is the solar input rating of the Anker SOLIX F3000?

The manufacturer lists up to 2,400 W of solar input. Check the station's voltage, current, and connector limits when selecting panels.

What does the manufacturer say about battery expansion for the Anker SOLIX F3000?

Up to 24 kWh with compatible expansion batteries

Current deals for this station

All deals

No verified manufacturer promotion currently lists this station. See all deals for brand-wide offers.

Relevant use cases

More from Anker

All Anker models

Sources

Manufacturer pages cited in the spec table. Check dates are listed beside each figure.

How specs are collected and compared: Methodology. Spot an outdated spec or broken link? Report an error .